Airfield Management Block 2 Practice Test

These questions are part of the practice quiz. Start practicing

• What is the elevation of the horizontal plane?
• Which navigation aid transmits non-directional signals to assist pilots in locating the station?
• What factors determine the dimensions of a Fixed-Wing parking apron?
• Which statement describes UAS Group 4?
• Which Hazard Class would cover Liquids?
• Which pad is used to perform full-power engine diagnostic testing while the engine is stationary?
• The surface described as being arranged symmetrically on the extended runway centerline is which surface?
• Which factor is most influenced by low RVR values?
• Which system primarily provides bearing information on VHF frequencies?
• Which statement correctly describes UAS Group 3?
• Which aircraft use Landing Zones (LZ) for war-fighting or contingency operations?
• Covered Wagon affects which PL levels?
• Arming and disarming aircraft with missiles near the runway threshold occurs on which pad?
• What is the definition of Max Takeoff Weight?
• Which statement describes a Basic Taxiway question?
• Which pad is designated for aircraft engine warm-ups during operations?
• What is the starting elevation for the transitional surface?
• How close may personnel approach the front of engine intake ducts when engines are running?
• ETL 9-1 covers what?
• Where does the sloped plane of the approach-departure clearance surface start?
• Which term indicates the minimum standoff distance required in safety planning?
• Which facility is used to wash aircraft as part of maintenance and does not require tie-downs or grounding points?
• What does the ILS provide?
• Where does the outer horizontal surface begin?
• Tail/Wing growth means?
• Class B runways are intended for which aircraft?
• GPS is unaffected by weather.
• What does POFZ stand for?
• How big is APZ I?
• Standard VFR Helipad is used when?
• Which pad is designated for loading explosives and other hazardous cargo?
• What is the primary purpose of runway designation numbers on the ground?
• How many satellites does the GPS constellation consist of?
• APZ II dimensions and where does it begin?
• Jettison areas are designated primarily for which use?
• Who determines the PL levels in this framework?
• What is the Mandatory Zone of Frangibility?
• RCL stands for which term?
• PL 4 category includes which exemplars?
• Which pad connects hangars to adjacent aircraft aprons?
• According to FAR, 4 NM equals how many feet?
• Runway Centerline Elevation is defined as which of the following?
• What does CAT I of the ILS provide?
• Which PL level is described as Strategic with examples AF 1 and Nuclear?
• What does RVR indicate?
• Which document addresses building an airfield for drones?
• Which zone ends at the runway end?
• How big are the shoulders on a B-52 or fighter runway?
• Which PL level covers War fighting including Aircraft and C3?
• C-17 LZ taxiway width?
• To describe a PL level that involves designated space and launch systems, which PL is it?
• ASR stands for Airport Surveillance Radar; what does it do?
• Who should coordinate to designate jettison areas?
• What does CAT II of the ILS provide?
• In explosive safety, what term describes exposing the minimum number of people to the minimum amount of ammunition for the minimum time?
• Which statement describes a High-Speed Taxiway?
• What is the width of the Mandatory Zone of Frangibility?
• What is the POFZ?
• Which statement best describes a Parallel Taxiway?
• How is the length of an aircraft measured?
• Which pad is used to calibrate the aircraft compass in magnetically quiet conditions?
• What elevation is given for the sloped plane?
• Which configuration is typically used to increase runway capacity by staggering operations?
• Fuel Spill Class III is defined as which condition?
• Which pad provides parking for multiple armed/alert aircraft with immediate runway access?
• Which of the following correctly describes the dimensions of the conical surface?
• What does a Taxilane represent?
• What is the width of a runway for a B-52?
• VORTAC stands for the combination of VOR and TACAN and provides which services?
• Which pad is used for loading explosives and hazardous cargo onto aircraft?
• What is the starting elevation above EAE for the conical surface?
• Where are clear zones located and what do they possess a high potential for?
• Which statement describes a Parallel Taxiway?
• Which nav aid is a combination of VOR and TACAN and provides bearing and distance information?
• What must graded areas be free of?
• In a rotary-wing taxiway, what is the shoulder width?
• ASR usage in surveillance.
• What does the Localizer provide?
• What is the approach-departure clearance surface composed of?
• What are shoulder dimensions for runways serving other aircraft types?
• Physical Security Measures typically include which elements?
• What distance must vehicles maintain from the refueling area?
• TACAN stands for Tactical Aircraft Nav.; designed for military use; uses UHF. What is its primary purpose?
• ASR provides range and bearing but not elevation.
• According to FAR, 3 NM equals how many feet?
• Which factor determines the length of a Class B runway?
• PL 3 category includes which exemplars?
• Which statement is true regarding the localizer's signal transmission direction?
• FAR 6+ NM equals how many feet?
• Under FAR Part 77, an obstruction is considered when the object height exceeds which criteria?
• PL 2 is associated with which category?
• What are the dimensions of the Mandatory Zone of Frangibility?
• C-17 LZ overrun length?
• During aircraft refueling, which condition may create a fire hazard?
• Which PPE level is required when testing hydrazine leaks?
• What does APZ stand for and what is it?
• Does the Established Airfield Elevation (EAE) vary with conditions?
• Distance from edge of shoulder to taxiway clear area in C-130 LZ?
• How wide are runway overruns?
• What is the length of the horizontal plane of the approach-departure clearance zone?
• Semi-Prepared LZ surface definition?
• Which statement defines Fuel Spill Class II?
• Which zone is located beyond the clear zones on the ground?
• IFR Helipad is used when?
• Hazardous Cargo Class 1 corresponds to which type of hazard?
• According to FAR, 5 NM equals how many feet?
• Which apron is located adjacent to a taxiway near the end of the runway?
• What is a Taxitrak?
• What is the ending elevation above EAE for the conical surface?
• Where is the graded area located and how big is it?
• Where are critical areas established?
• Hazardous Cargo Class 6 corresponds to which hazard?
• The graded area is located inside which zone?
• What does AGL stand for?
• Where are jettison areas usually located?
• Hazardous Cargo Class 2 corresponds to which hazard?
• Which factors influence the length of a C-17 LZ?
• What minimum distance must unauthorized personnel stay from aircraft with active rotor blades?
• Which statement describes the general purpose of a taxiway on an airfield?
• What is the function of Taxilanes?
• When testing for hydrazine leaks, what PPE is required?
• Which ILS component provides runway centerline course guidance?
• What is the slope ratio of the sloped plane?
• Which statement describes UAS Group 2?
• Which statement describes a single runway?
• What is the starting width of the horizontal plane?
• Which of the following best defines Fuel Spill Class II?
• Does the horizontal plane have any slope?
• RVR stands for what?
• Parallel runways are characterized by what?
• How is runway designation identified?
• Does RCL vary?
• What are the C-130 LZ dimensions?
• How big are the shoulders on runways serving other aircraft types?
• What distance defines the Fuel Servicing Safety Zone (FSSZ) around a pressurized fuel servicing component and around aircraft vent outlets?
• Mean Sea Level refers to which concept?
• APZ II begins at the end of which zone?
• The POFZ begins at which location?
• Under what condition may personnel approach closer than the standard distances to engine intake ducts?
• What does FAR Part 77 stand for?
• If a substance is corrosive, it belongs to which Hazard Class?
• What is the length of the sloped plane of the approach-departure clearance surface?
• How long are runway overruns?
• PL 1 is associated with which category?
• ASR provides range up to 60 NM with 360-degree coverage.
• What is UFC 3-260-01 primarily used for?
• Which pad is used for calibrating the aircraft compass in magnetically quiet conditions?
• What is the primary purpose of the Instrument Landing System?
• What is the starting width of the sloped plane of the approach-departure clearance surface?
• Which statement accurately describes Fixed-Wing Taxiway Dimensions?
• Which hazardous cargo class would include Poisonous materials?
• Which pad is designated for engine warming prior to testing?
• What does VOR stand for and what does it provide?
• GPS orbit and operation.
• What are the dimensions of a Class B runway?
• Prepared LZ surface definition?
• Hazardous Cargo Class 9 corresponds to which hazard?
• What does UAS stand for in the material?
• What type of aircraft are Class A runways intended for?
• What best describes UAS Group 1?
• C-130 LZ taxiway width?
• Where does the outer horizontal surface end?
• Where does the conical surface end relative to the runway centerline?
• Which class would cover Miscellaneous hazardous materials?
• How big is the POFZ?
• What are the dimensions of the primary surface?
• Which description best defines Fuel Spill Class I?
• During reduced visibility, what is the maximum advised speed?
• What are turning capabilities?
• GPS stands for Global Positioning System. Which option correctly lists a correct expansion?
• Which of the following describes the dimensions of the outer horizontal surface?
• What is the shoulder width for a C-17 LZ?
• Does the outer horizontal surface have a slope?
• What is the recommended orientation for arming aircraft immediately before takeoff and disarming upon return?
• What does ADF stand for, and what does it indicate?
• What does ILS stand for?
• Limited Use VFR Helipad is used for what type of operations?
• Which paved area connects hangars with adjacent aircraft aprons?
• What are the dimensions of clear zones?
• What are the dimensions of a Standard VFR Helipad?
• What is the ending elevation for the transitional surface?
• What is the minimum width of the transitional surface?
• Hazardous Cargo Class 5 corresponds to which hazard?
• What is the standard width of a rotary-wing taxiway?
• LZ use duration definitions?
• Above Ground Level refers to what kind of measurement?
• Where is the Localizer located and where does it transmit its signal?
• Which helipad type has a 50x50 ft size with 25 ft shoulder?
• Hazardous Cargo Class 7 corresponds to which hazard?
• What is the slope ratio of the conical surface?
• Which PL level is associated with Operations; Tower?
• What is the width of the outer horizontal surface?
• Crosswind runways configurations provide greater capacity through what arrangement?
• How far is the rotary-wing taxiway lateral clearing zone from the centerline?
• Where does the transitional surface begin?
• Which document provides Airfield and Heliport Planning and Design standards?
• What does EAE stand for?
• What is the ending width of the horizontal plane?
• Which statement is true about Class B runway width?
• Which statement describes UAS Group 3?
• Hazardous Cargo Class 3 corresponds to which hazard?
• What is the slope ratio of the transitional surface?
• Hazardous Cargo Class 4 corresponds to which hazard?
• Which PL level includes designated space and launch systems?
• Which AFH goes along with Aircraft Dimensions?
• PL 1 category exemplars include which description?
• What is the width of a Class B runway?
• What are the dimensions for Limited Use VFR Helipad?
• Which description defines a Basic Taxiway?
• Runway designation consists of which feature on the runway?
• Which statement about CAT I and CAT II decision heights is correct?
• Which statement correctly describes UAS Group 5?
• What does MSL stand for?
• Which statement describes UAS Group 5?
• How is the wingspan of an aircraft measured?
• Which surface is 2000 ft wide and centered on the runway?
• How many distinct helipad types are described?
• Who designates controlled areas?
• What is the shoulder width for B-52 or fighter runways?
• Who operates GPS?
• Hazardous Cargo Class 8 corresponds to which hazard?
• What does NDB stand for and what does it do?
• What are the dimensions of a runway lateral clearance zone?
• What is the ending width of the sloped plane?